BOB Gear Stroller Bedienerhandbuch PDF herunterladen (Seite 9)

9

OMA46B

FRONT WHEEL INSTALLATION

1. Install Front Wheel Quick Re-

lease Lever

Remove Tension Adjusting Nut

from quick release rod and take

off ﬁ rst spring. Slide quick release

rod through front wheel axle, place

spring back on quick release rod,

small side toward axle, and thread

tension adjusting nut back on.

NOTE: Prior to installing the front

wheel it is necessary to open the

brake quick release to provide clear-

ance for the wheel/tire to pass the

brake pads.

2. Open Brake Quick Release

Open the brake quick release by

rotating the brake quick release lever

in the clockwise direction.

OPEN

3. Rotate Front Wheel Quick

Release Lever

Rotate quick release lever so that it

curves away from the wheel. This

places it in the FULLY OPEN position.

O

P

E

N

Quick Release Lever

FULLY OPEN FULLY CLOSED

4. Insert Front Wheel

When facing the front of the stroller,

insert the wheel between the fork

dropouts so that the axle ﬁ rmly

contacts the top of the slots of the

fork dropouts.

5. Adjust Quick Release Lever

To adjust the quick release, hold the

quick release cam lever in the FULLY

OPEN position with your right hand

as shown. Tighten the tension adjust-

ing nut with your left hand until it is

ﬁ nger tight against the fork dropout.

6. Close Quick Release Lever

To properly close the quick release

and secure the front wheel in

the dropouts, conﬁ rm the axle is

contacting the top of the dropouts

on both sides and the wheel is

centered left to right.

Dropout

Tension Adjusting Nut

Quick Release Lever

Brake Quick Release

Tension Adjusting Nut

Spring Quick Release

Rod

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 19 20

Kommentare zu diesen Handbüchern

Keine Kommentare